Nvidia system monitor not working1/28/2024 ![]() The accepted value for ConnectedMonitor are CRT, DFP and TV anything attached to a 15 pin VGA connector is regarded by the driver as a CRT. If these changes still don't work try enforce monitor detection adding these lines to the "Device" section: In the section "Device" then reboot in order the changes take effect. Placed in the section "Monitor" DON'T USE THESE VALUES you must edit and set the horizontal and vertical frequencies reading/googling your monitor name and model specification datasheet! If the values are wrong set the right value in nf then you must also add this line: First you can check that correct monitor frequencies are detected: run nvidia-settings program choose the "X Server Display Configuration" tab then click the "Save To X Configuration File" button then click "Show previw." in the view showed look for these two lines: I assume you have already a file named like nf placed in /etc/X11// to edit and the package nvidia-settings installed. To sign Nvidia modules and make them work with Secure Boot, follow those instructions.Īn easier alternative is to disable Secure Boot in your system's BIOS. Systemd-modules-load logs will clearly show errors related to the nvidia module.Īnother symptom of Nvidia module not loaded is nvidia-settings not starting: $ nvidia-settingsĮRROR: Unable to load info from any available system If you don't sign the generated modules, you will see the following in boot logs: Failed to start Load Kernel Modules This page describes issues and workarounds relating to the NVIDIA proprietary display driver.Īlthough Secure Boot is now supported by Debian, the NVIDIA driver requires DKMS, which requires additional setup to be used with Secure Boot. NVIDIA Proprietary Driver: Troubleshooting ![]() Translation(s): English - Español - Français
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |